|
|
|
|
|
Mechanical Timer
0 - 60 Second |
 |
 |
(KTD) TE605
Incredibily cool!! Mechanical timer. Manually
set dial from front from 0 - 60 seconds. 115v, 60 Hz motor. Contacts: 115v @ 15 amps.
Single pole, normally open. 3-3/4"D face, 3-1/8" hole required, 3-1/16" depth
behind panel. Made by R.W. Cramer Company in 1954. Brand new in the box!! |
|
|
Flasher Unit |
 |
(KTD) BF-81
Hughey & Phillips flasher unit. Timer motor
cycles a mercury switch every 2 seconds. Made for radio tower lights to cycle on & off.
Switch handles 2.8 kva. Motor is rated at 117 vac. |
|
| |
|
|
Adjustable Time Delay Relay
15 - 90 Second |
 |
 |
(KTD) M11419
A.W. Hayden adjustable time delay relay. 15
- 90 seconds. 115v, 60Hz timer motor. 3 internal SPDT micro switches, one of which is
used as end stop for motor. Used / removed. Circa: 1950's - 1960's. Dented. |
| $25 each |
|
|
(KTD) M11418
A.W. Hayden adjustable time delay relay same
as above except 1.5 - 9 seconds. |
|
|
Electric Motor-Driven Timer
115 vac |
 |
 |
(MOT) S-1
The Standard Electric Time Company OLD electric
motor-driven timer. 115 vac. 1/100th second resolution. 1 full sweep of second hand
= 1 second. Smaller red hand counts 60 seconds total.
Reset lever on top. Timer starts when AC switch is made. Stops
when AC is removed. Old bakelite case is missing pieces but the clock works fine. |
|
|
|
|
Time Delay Relay
10 Seconds + Adjustment
|
 |
|
(KTD) NE11
Agastat time delay relay. 10 seconds + adjustment.
DPDT, 15 amp contacts. Delay on energize. 440 vac @ 60 Hz coil. Measures 4-1/2" x 2-9/16"
x 2-9/16". |
|
|
Interval Timer
4 Hour Cycle |
 |
 |
 |
(KTD) 511ACC3-4H
Conrac interval timer. 4 hour cycle. 115
vac, 60 Hz. Three (3) SPDT 20 amp switches are individually adjustable on common
cam. 3" x 2" x 4-1/2"H. |
|
| |
|
|
|
Deep Fat Fryer Timer
0-15 Minutes
|
 |
(KTD) 47012-62
FLAVOR-CRISP timer made by Deltrol (model 138-OD) is standard issue for pressure cookers but will
control any 240 vac appliance up to 6.5 amps. 240 vac control
voltage. Spade terminals.
Dial in any time between 0-15 minutes. Removable
graduated dial. 2-1/2" x 3" x 3" deep. Used. |
|
|
|
|
|
Timer
0 - 30 Minutes |
 |
(KTD) 138OD
FLAVOR-CRISP timer as above but 0-30 minutes. Deltrol control also 240 vac up
to 6.5 amps. |
| $25 each - $20 (3+) |
|
| |
|
|
Synchronous
Reset Timer
0 - 30 Minutes
|
 |
(KTD) HP55-A6
Eagle Signal Controls Cycle-Flex model
HP55-A6-L1688 timer is the highest quality for restaurant or
any industrial use. 10 amp contact rating. 120 vac control
voltage. Screw terminals. Dial in any time between 0-30 minutes. 4-1/4" x
3-3/4" wide chrome bezel. 4-1/4" behind panel depth. |
| $119 each |
|
|
(KTD) HP55-A6/B
Same as above but mounted in a metal
Bud Box 6" x 6" x 6". Has
start and stop push buttons. New Ballantyne product. Only 1 available. |
|
| |
|
|
Timer / Project
Box
0 - 5 Seconds
|
 |
(KTD) R3-T-602
Ballantyne Timer Box contains an Omron
H3G-8C timer and four 0.5 ohm, 50 watt Dale resistors. Plug
in timer relay has DPDT, 5 amp contact rating and 120
vac control voltage plus nice octal hard wire base. Dial in any time between
0-5 seconds. 4" high x 5" x 6" Bud CU-729 box with removable
top and bottom. |
|
|
Event Counter
DPDT - 30 amp - 115 vac Coil
|
 |
(KO) 99XBX102
Truly a mechanical wonder from the
pre-transistor days. Energize the event coil (shown left) 4
times (115 vac) and on the 4th, 30 amp DPDT contacts are made.
If the event coil is tripped more than 4 times, nothing happens. The release
coil (shown right) resets the cam to zero, with contacts also resetting. 5" x
7" x 3-1/2" high. |
|
|
|
|
20 Minute Delay
SPDT - 7 amp - 115 vac |
 |
(KTD) M11452
Motor driven time delay in hermetically
sealed chamber. Preset 20 minute delay on operate. 7 amp SPDT
contacts. 115 vac control circuit. 4-3/8" x 2-1/4" x
5" high. 8/32 bottom studs. |
|
|
2 Second Delay
SPDT - 5 amp - 115 vac
|
 |
(KTD) 61S3-2
Motor driven time delay in hermetically
sealed chamber. Preset 2 second delay on operate. 5 amp SPDT
contacts. 115 vac control circuit. 4" x 3-3/4" x
3-3/8" high. 1/4" bottom studs. |
|
| |
|
|
